glossary:glossary_p
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
glossary:glossary_p [2014/11/11 13:29] – external edit 127.0.0.1 | glossary:glossary_p [2020/12/07 16:23] – move POR to correct location JohnFletcher | ||
---|---|---|---|
Line 11: | Line 11: | ||
- The condition in which two comparably sized objects or figures are equidistant at all facing points parallel).\\ | - The condition in which two comparably sized objects or figures are equidistant at all facing points parallel).\\ | ||
- | ===== PCB - Printed Circuit Board ===== | + | ===== PCB ===== |
- | Usually | + | Printed Circuit Board. Are usually |
Line 26: | Line 26: | ||
The PECO implementation of the Point motor, notable because they are constructed so as to be directly attached to both N and 00 gauge PECO track, thus making it easier to line up the pull and throw of the point | The PECO implementation of the Point motor, notable because they are constructed so as to be directly attached to both N and 00 gauge PECO track, thus making it easier to line up the pull and throw of the point | ||
+ | |||
+ | ===== PEI ===== | ||
+ | |||
+ | [[wp> | ||
+ | Used for the printable surface on some 3D printers, especially the Prusa range | ||
Line 35: | Line 40: | ||
- | ===== Phase Modulation (PM) ===== | ||
+ | ===== PIC ===== | ||
+ | Peripheral Interface Controller. A complex integrated circuit which may be programmed to carry out a controlled sequence of events, ie certain output events controlled by an input event. | ||
- | A specialist modulation mainly | + | A brand of micro processor chip from Microchip, often used in MERG projects. Eg PIC18F2480. |
+ | ===== PICKit ===== | ||
+ | A device marketed by [[http:// | ||
+ | The pin out of the PICKit differs from that of the programming connector on MERG CBUS boards, see **[[helpsystem: | ||
+ | ===== PiSo ===== | ||
+ | **P**arallel **i**n **S**erial **o**ut, refers to a type of [[glossary_s# | ||
+ | =====PLA===== | ||
+ | [[wp> | ||
+ | [[wp> | ||
+ | ===== PM - Phase Modulation ===== | ||
- | ===== PIC ===== | + | Phase Modulation. A specialist modulation mainly used in Radar equipment, the phase rather than the frequency of the carrier wave is varied in order to obtain information |
- | A complex integrated circuit which may be programmed to carry out a controlled sequence | + | ===== PM - Pulse Modulation ===== |
+ | |||
+ | |||
+ | There are basically 3 forms of pulse modulation, Amplitude, Position, and width, each having its own characteristics and uses. This type of modulation may be superimposed onto RF or on DC voltages. | ||
Line 62: | Line 80: | ||
- | Solenoid Point motor /relay driver with onboard | + | Solenoid Point motor /relay driver with on board relay see TBG16/26 |
+ | ===== PMP ===== | ||
+ | Pocket Money Project. Excellent simple, basic and inexpensive kits to learn basic electronic theory and techniques such as soldering. Currently there are 23 Kits and most cost less than £2.00. You can find them in the Kit Locker [[https:// | ||
===== PNP ===== | ===== PNP ===== | ||
Line 98: | Line 118: | ||
- The orientation of the positive and negative poles in a battery or power supply relative to a circuit. | - The orientation of the positive and negative poles in a battery or power supply relative to a circuit. | ||
- The orientation of a magnetic field, relative to the surrounding environment. | - The orientation of a magnetic field, relative to the surrounding environment. | ||
+ | |||
+ | |||
+ | ===== POR ===== | ||
+ | |||
+ | |||
+ | |||
+ | Power on reset i.e. just turning the power on to the whole system. | ||
Line 104: | Line 131: | ||
Abbreviation for Potentiometer see below | Abbreviation for Potentiometer see below | ||
+ | |||
Line 140: | Line 168: | ||
- | Power supply unit | + | Power supply unit\\ |
+ | See also [[glossary: | ||
===== PTP ===== | ===== PTP ===== | ||
Line 148: | Line 176: | ||
RPC System - PTP (Point-to-Point) | RPC System - PTP (Point-to-Point) | ||
+ | ===== PTP-Lite ===== | ||
+ | Multiplex system using a RS485 bus, matching pairs of input and output modules communicate under the control of a master module.\\ | ||
+ | For details see these TBs: | ||
+ | [[http:// | ||
+ | [[http:// | ||
+ | [[http:// | ||
+ | [[http:// | ||
+ | [[http:// | ||
===== Pulse ===== | ===== Pulse ===== | ||
Line 155: | Line 191: | ||
- | ===== Pulse Modulation ===== | ||
+ | ===== Pulse Width Modulation ===== | ||
- | There are basically 3 forms of pulse modulation, Amplitude, Position, | + | Pulse Width Modulation is a technique used to control devices such as motors and lights to vary the amount |
===== Pulsed output ===== | ===== Pulsed output ===== | ||
Line 165: | Line 200: | ||
{{: | {{: | ||
- | |||
- |
glossary/glossary_p.txt · Last modified: 2021/08/08 05:25 by Wayne