glossary:glossary_p
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
glossary:glossary_p [2018/02/18 09:06] – [PICKit] Bob Vetterlein | glossary:glossary_p [2018/06/25 15:28] – [PICKit] Bob Vetterlein | ||
---|---|---|---|
Line 26: | Line 26: | ||
The PECO implementation of the Point motor, notable because they are constructed so as to be directly attached to both N and 00 gauge PECO track, thus making it easier to line up the pull and throw of the point | The PECO implementation of the Point motor, notable because they are constructed so as to be directly attached to both N and 00 gauge PECO track, thus making it easier to line up the pull and throw of the point | ||
+ | |||
+ | ===== PEI ===== | ||
+ | |||
+ | |||
+ | Used for the printable surface on some 3D printers, especially the Prusa range | ||
Line 42: | Line 47: | ||
===== PICKit ===== | ===== PICKit ===== | ||
A device marketed by [[http:// | A device marketed by [[http:// | ||
- | The pin out of the PICKit differs from that of the programming connector on MERG CBUS boards, see [[helpsystem: | + | The pin out of the PICKit differs from that of the programming connector on MERG CBUS boards, see **[[helpsystem: |
===== PiSo ===== | ===== PiSo ===== | ||
**P**arallel **i**n **S**erial **o**ut, refers to a type of [[glossary_s# | **P**arallel **i**n **S**erial **o**ut, refers to a type of [[glossary_s# |
glossary/glossary_p.txt · Last modified: 2021/08/08 05:25 by Wayne