Differences

This shows you the differences between two versions of the page.

--- glossary:rpcsystem [2013/04/24 15:54] – WhiteCF
+++ glossary:rpcsystem [2014/11/11 13:29] – external edit 127.0.0.1
@@ Line 18: / Line 18: @@
 ==== The Stack ====
-Connectors on the stack modules carry power lines 0V and +5V for the electronics on each board, attached devices may require separate supplies. There are four control lines, these are Data out, Data in, Clock and Strobe. When the interface receives a message the Strobe line is activated in order to read the current state of Inputs into the shift registers. The Clock is then activated in multiples of 8 pulses and data is sent out and received by the interface. When shifting is complete the Strobe line is activated again to output the new data to the layout devices.
+Connectors on the stack modules carry power lines 0V and +5V for the electronics on each board, attached devices may require separate supplies. There are four control lines, these are Data out, Data in, Clock and Strobe. When the interface receives a message the Strobe line is activated in order to read the current state of Inputs into the shift registers. The Clock is then activated in multiples of 8 pulses and data is sent out and received by the interface. When shifting is complete the Strobe line is activated again to output the new data to the layout devices. See [[:glossary:shiftinout| here]] for an illustrated explanation of Shift Register operation.
 ==== PTP ====